Old Blood Noise Fault Overdrive Distortion Pedal
The Old Blood Noise Endeavors Fault is an overdrive and a distortion. It’s simple and not an outside-of-the-box, whacky take on crunched-up guitar signal. It does what it does - to provide the player with ample tonal and gain shaping options in a single package.
The Fault Overdrive/Distortion is the drive you didn't even know you needed. It can push your amp over the edge, provide a sensitive drive for a clean signal or act as an all-out distortion for your chugging rhythms, singing leads or noise experiments.
A Bypass switch turns it on and off. Volume makes it louder. Gain 1 sets the intensity of the first gain stage and Fault can go from light and sparkly, to tight and crunchy. Pretty sweet and simple, huh?
Now on to the powerful tone sculpting 3-band EQ at the heart of it all. The Low, Mid and High controls each cut or boost their respective frequencies - scoop it, hump it, flatten it - whatever your heart desires. Low is a 100 Hz shelf filter, Mid is 500 Hz bell and High is 3 kHz shelf. Jangly rhythms, fat leads or chords with just the right amount of mid-push to see you push through the mix. It’s all in there buddy!
Gain 2 is activated by the Gain 2 footswitch. If it's off or if the knob is all the way down, it does nothing. But turn the switch on and the knob up and you'll find increasingly heavy distortion in a pedal you thought was only an overdrive. Gain 2 is highly interactive with where you’ve set Gain 1, letting you conjure a myriad of delightfully driven and distorted sounds.
So just plug in and rock out!
- Dual gain overdrive pedal - goes from clean boost to all-out distortion
- 3-band EQ - delivers precise control over low, mid and high frequencies
- Gain 2 channel - lets you go from light overdrive to heavy distortion on the fly
- Made in the USA
- Powered by 9V DC PSU (centre -, 2.1mm, ~31mA current draw)